How to Lay Tongue and Groove Flooring

Tongue and groove flooring is a type of installation that occurs when the planks of flooring are fit together edge to edge to allow the pieces to be joined together to create a singular surface that is nice and flat. Working with Gilbert flooring professionals on laying tongue and groove flooring is the best way to ensure a professional end result. However, no matter which professional you bring into the fold, understanding the step-by-step process ensures that you have a clear idea of what it takes to achieve an amazing flooring solution.

To start, remove any baseboard or moldings and make sure to sweep the floor well. Set any nails that may be popped up and make sure that the floor is properly prepared to for you to start working on it. If you are unsure of what steps need to be taken to prepare your floor, work with a Gilbert flooring representative to find out exactly what needs to be done.

 

Step 1: Nail the initial board into place. When you lay down the piece of laminate, make sure the edge with the groove is about 3/8 of an inch away from the wall. At a 45 degree angle, drill pilot holes using flooring nail into the tongue every 12 inches.Gilbert Flooring

Step 2: Tap boards together to keep them parallel. Use a piece of wood to serve as a driving block to keep the flooring from being damaged in the process.  Offset each of the neighboring joints by roughly 2 inches; if you are unsure of the measurements, be sure to talk with your Gilbert flooring professional to inquire.

Gilbert flooring

Step 3: Load the flooring nailer with staples and play around with depth settings. Each staple head should go in just below the surface of the wood. Then, make sure the nailer fits to the tongue, laying flat and get it into place with a mallet.

Gilbert Flooring

Step 4: Measure out what you need before cutting the last piece, and cut with a power or circular saw. However, be sure that you don’t cut off the edge with either the groove or the tongue that you need to get everything in place. Then, measure out a piece of line about every six courses or so.

Gilbert Flooring

Step 5: Cut off casings around the bottom of the pieces. Use a compass to scribe around the irregularities and use a saber saw to cut what you need to.

gilbert flooring

Step 6: Finalize the flooring: Use a piece of wood to protect the wall and tighten the last courses of your project using a pry bar.